Road markings
Contents
Road markings are placed directly on the road surface. They may take the form of:
- solid and broken lines,
- single and double lines,
- arrows,
- inscriptions,
- symbols,
- markings designating specific places on the road,
- reflective road studs.
Road markings are not merely a supplement to upright road signs. Some of them independently impose a requirement or prohibition, or determine how a particular traffic lane is to be used.
1. White and yellow markings
Road markings may be white or yellow.
If white and yellow markings are present on the road at the same time and indicate different ways of proceeding, the driver must follow the yellow markings.
Yellow lines are often used for temporary traffic management, for example during road works.
Remember:
yellow markings conflicting with white markings → follow the yellow markings
This does not mean that all white road markings automatically cease to apply. Yellow markings take precedence where the two sets of markings indicate different ways of proceeding.
Reflective road studs
Reflective road studs may additionally mark:
- the right-hand edge of the carriageway — red,
- the left-hand edge of the carriageway and traffic lanes — white or yellow.
LINES MARKING TRAFFIC LANES AND CARRIAGEWAY EDGES
2. P-1 "single broken line"
P-1 marks traffic lanes.
In its basic form, the dashes are:
- shorter than the gaps, or
- equal in length to the gaps.
Crossing P-1 is permitted unless prohibited by other regulations, signs or traffic conditions.
Double-width P-1
If P-1 is double width and the dashes and gaps are of equal length, it additionally indicates that the marked lane is:
- a slow-vehicle lane,
- an ending lane, or
- a lane intended exclusively for vehicles leaving for another road or carriageway.
Not every broken line therefore has the same function.
3. P-2 "single solid line"
P-2 separates traffic lanes running in the same direction.
It also means:
- you must not cross the line,
- you must not drive on the line.
Pitfall: it is not enough for all the vehicle's wheels to remain on their own side. Driving on P-2 itself is prohibited.
4. P-3 "line crossable from one side only"
P-3 consists of:
- a solid line,
- a broken line.
From the broken-line side
The line may be crossed if the other regulations and the traffic situation allow it.
From the solid-line side
You must not:
- cross the line,
- drive on it.
Important exception following the 2026 change
Since 19 February 2026, the regulation expressly provides that P-3 may be crossed from the solid-line side in order to return after overtaking to the traffic lane occupied before overtaking, adjacent to the broken line, on a two-way carriageway.
Example:
- the driver begins overtaking by crossing P-3 from the broken-line side,
- when returning to their lane, the driver is already on the solid-line side,
- the driver may cross the solid line to complete the overtaking manoeuvre and return to the lane occupied before overtaking.
This exception is not a general permission to cross P-3 from the solid-line side. It applies specifically to returning after overtaking on a two-way carriageway.
5. P-4 "double solid line"
P-4 separates traffic lanes running in opposite directions.
You must not:
- cross the line,
- drive on it.
Do not confuse:
- P-2 — a single solid line between lanes running in the same direction,
- P-4 — a double solid line separating opposite directions of traffic.
Crossing or driving on the line is prohibited in both cases, but the lines perform different traffic-management functions.
6. P-5 "double broken line"
P-5 placed between intersections on both sides of a traffic lane marks a reversible lane.
Such a lane is opened and closed by traffic light signals displayed by the S-4 traffic light.
You cannot use the lane based solely on the appearance of P-5. You must observe the traffic lights above the lane.
7. P-6 "warning line"
P-6 is a broken line in which the dashes are longer than the gaps.
It warns that you are approaching:
- a line that must not be crossed, or
- a dangerous place.
If a driver sees an ordinary broken line change into P-6, they should expect that the opportunity to change lanes or cross the centre of the carriageway may soon end.
8. P-7a and P-7b — edge lines
P-7a "broken edge line"
Marks the edge of the carriageway.
P-7b "solid edge line"
Also marks the edge of the carriageway, but additionally means that the driver of a motor vehicle must not enter the verge.
This is an important distinction:
- P-7a → marks the edge,
- P-7b → marks the edge + prohibits a motor vehicle from entering the verge.
ARROWS AND DIRECTIONS OF TRAVEL
9. P-8a, P-8b and P-8c — direction arrows
P-8a, P-8b and P-8c mean that from the traffic lane on which they are placed, you may travel only in the direction indicated by the arrow.
If the symbols are combined, all directions shown by the marking are permitted.
P-8a "direction arrow — straight ahead"
From the traffic lane on which the marking is placed, you may travel only straight ahead.
P-8b "direction arrow — turn"
From the traffic lane on which the marking is placed, you may travel only in the turning direction indicated by the arrow.
P-8c "direction arrow — U-turn"
From the traffic lane on which the marking is placed, you may travel only in the U-turn direction indicated by the arrow.
Turning left and making a U-turn
An arrow permitting a left turn, placed in the far left-hand lane, also permits a U-turn.
The exceptions are where:
- B-23 prohibits a U-turn, or
- traffic is controlled by an S-3 traffic light.
This is the same important rule covered earlier with F-10 and F-11.
10. P-9 "guidance arrow"
P-9 means that you must move into the adjacent traffic lane indicated by the arrow.
It most commonly appears before:
- the end of a traffic lane,
- an obstruction,
- a change in traffic management.
The exception applies to drivers of vehicles for which the further section of that lane is intended.
Remember: P-9 is not merely a warning that the lane is ending. It is a marking requiring the appropriate lane change.
PEDESTRIAN AND CYCLE CROSSINGS
11. P-10 "pedestrian crossing"
P-10 marks the location of a pedestrian crossing.
It may be used together with the upright D-6 sign.
Do not confuse:
- A-16 — warns of a pedestrian crossing,
- D-6 — indicates a pedestrian crossing,
- P-10 — marks it on the road surface.
12. P-11 "cycle crossing"
P-11 marks the location of a cycle crossing.
It may be used together with D-6a or D-6b.
As with a pedestrian crossing, the full rules on priority and driver behaviour will be covered in the module on pedestrians and cyclists.
STOP AND GIVE-WAY LINES
13. P-12 "stop line — STOP"
P-12 indicates the place where the vehicle must be stopped in connection with:
- B-20 "STOP", or
- B-32 requiring the vehicle to stop.
If P-12 is marked, the vehicle should be stopped before this line.
14. P-13 "give-way line made up of triangles"
P-13 indicates the place where the vehicle is to be stopped in order to give way as required by A-7 "Give way".
The conditional nature of the line is important.
P-13 does not require you to stop every time. You stop the vehicle when this is necessary in order to give way.
15. P-14 "conditional stop line made up of rectangles"
P-14 indicates the place where the vehicle is to be stopped, including:
- at approaches of roads of equal status,
- before a pedestrian crossing,
- before a tram stop without a boarding island,
- before a tram crossing or level crossing,
- before a cycle crossing,
- before a cycle box,
- before a traffic light signal.
As with P-13, the line does not impose an absolute requirement to stop every time. It marks the place where the vehicle should be stopped if the situation or the regulations require stopping.
P-12, P-13 and P-14 — comparison
- P-12 → an absolute stop associated, among other things, with B-20,
- P-13 → the place where you may need to stop in connection with A-7,
- P-14 → the place where you may need to stop in other specified situations.
16. P-15 "give way triangle"
P-15 confirms that an approach to an intersection is marked with the upright A-7 sign.
17. P-16 "STOP inscription"
P-16 confirms that an approach to an intersection is marked with the upright B-20 "STOP" sign.
P-15 and P-16 are therefore not arbitrary symbols painted on the road. They reinforce the information conveyed by upright signs regulating priority.
STOPS AND PARKING
18. P-17 "bus stop line"
P-17 marks on the carriageway the location of a stop for public transport vehicles specified in the regulations.
It also means that the prohibition on other vehicles stopping at the stop applies along the entire length of the line.
19. P-18 "parking space"
Marks a place intended for parking vehicles.
20. P-19 "parking lane line"
It marks:
- a lane intended for parking vehicles along the edge of the carriageway, or
- a parking bay separated from the carriageway.
21. P-20 "reserved parking space ("envelope")"
Marks a parking space reserved for a specified type of vehicle.
The "envelope" marking itself does not determine for whom the space is reserved. This follows from the other road markings or signs.
22. P-21 "area excluded from traffic"
Marks an area of the road where:
- entry is prohibited,
- stopping is prohibited.
An area excluded from traffic must not be treated as an additional lane or as a place that can be used to bypass a traffic jam.
USE OF A LANE OR PART OF THE ROAD
23. P-22 "'BUS' inscription"
Indicates a traffic lane intended for vehicles carrying passengers for payment on regular routes.
The lane may also carry other inscriptions or symbols defining its use.
You must therefore always read the entire marking, not just the BUS inscription.
24. P-23 "bicycle"
It may indicate:
- a cycle path,
- a cycle lane,
- a cycle box,
- part of the carriageway of a one-way road on which two-way cycling is permitted.
If P-23 is used together with P-26, the path is intended for pedestrians and cyclists.
A cycle cart may also use a part of the road marked with P-23 where permitted by upright road signs.
25. P-24 "parking space for a disabled person's vehicle"
Marks a parking space intended for the motor vehicle of an entitled person under the rules laid down in the regulations.
In practice, this marking is used together with signs indicating a space intended for a person holding the appropriate entitlement to use the parking space.
26. P-25 "speed hump"
Marks a raised section of the carriageway used to slow vehicle traffic.
Do not confuse:
- A-11a — warns of a speed hump,
- P-25 — marks the speed hump itself on the carriageway.
27. P-26 "pedestrians"
Indicates a pedestrian path.
If P-26 is placed together with P-23, the path is intended for:
- pedestrians,
- cyclists.
28. P-27 "bicycle direction and path of travel"
Indicates to a cyclist:
- the bicycle's path of travel on the carriageway,
- its direction of travel.
P-27 does not mark a cycle lane in the same way as P-23. It indicates the recommended or intended path and direction of travel for a cyclist on the carriageway.
Detailed rules for cycling are covered in
M5.4.
How to read road markings in a real traffic situation
Before carrying out a manoeuvre, it is worth checking in order:
- Is the line solid or broken?
- Is it single, double or crossable from one side only?
- Which side of P-3 am I on?
- Are there direction arrows in the lane?
- Does the lane end, or do I have to leave it?
- Are there yellow lines temporarily changing the traffic arrangement?
- Is the area I intend to enter excluded from traffic?
- Does the road marking operate together with an upright road sign or traffic light?
Only after considering all this information should you determine which manoeuvre is permitted.
Common pitfalls
1. Yellow markings take precedence over white markings if the two indicate different ways of proceeding.
2. P-2 and P-4 are not the same. P-2 separates lanes running in the same direction; P-4 separates opposite directions of traffic.
3. You must not drive on a solid line either.
4. P-3 must be read from the side on which the vehicle is travelling. From the solid-line side, crossing is prohibited, subject to the statutory exception for returning after overtaking on a two-way carriageway.
5. P-6 is not an ordinary P-1. The longer dashes warn that you are approaching a line that must not be crossed or a dangerous place.
6. P-7b also prohibits a motor vehicle from entering the verge.
7. A left arrow in the far left-hand lane may also permit a U-turn.
8. P-9 requires a lane change; it does not merely inform you that the lane is ending.
9. P-12 must be distinguished from P-13 and P-14.
10. You must neither enter nor stop on P-21.
Full list of road markings covered in this lesson
Show the full list of signsHide the full list of signs
Sources
- Rozporządzenie Ministrów Infrastruktury oraz Spraw Wewnętrznych i Administracji z dnia 31 lipca 2002 r. w sprawie znaków i sygnałów drogowych — Chapter 4, § 85–94.
- Consolidated text: Dz.U. 2019 poz. 2310, as subsequently amended.
- Rozporządzenie z dnia 14 stycznia 2026 r. zmieniające rozporządzenie w sprawie znaków i sygnałów drogowych — Dz.U. 2026 poz. 133, effective from 19 February 2026.
- 2026 change concerning P-3: clarification that the exception allowing the line to be crossed from the solid-line side in order to return after overtaking applies to returning to the previously occupied lane on a two-way carriageway.
- Annex No. 1 to the rozporządzenie w sprawie szkolenia osób ubiegających się o uprawnienia do kierowania pojazdami —
officialTopic 1.4.
