Traffic lights
Contents
Traffic lights are used to control the movement of vehicles, pedestrians and cyclists, as well as to organise traffic in specific traffic lanes.
The most important rule from the previous lessons is:
traffic light signals take precedence over road signs regulating priority.
This does not mean, however, that a green light "switches off" all other signs and rules.
The driver must still comply, among other things, with:
- prohibitory and mandatory signs,
- traffic-lane markings,
- rules concerning pedestrians and cyclists,
- conditions at the intersection,
- instructions given by a person directing traffic, if such a person is present on the road.
1. S-1 — basic traffic lights for drivers
The S-1 traffic light displays the basic signals:
- green,
- yellow,
- red,
- red and yellow simultaneously.
Green signal
A green signal means permission to proceed beyond the traffic light.
It does not, however, give an unconditional right to enter the intersection.
When must you not proceed despite a green light?
A green signal does not permit entry beyond the traffic light if:
- the vehicle's movement would make it difficult for pedestrians or cyclists to leave the carriageway,
- because of traffic conditions at or beyond the intersection, it would not be possible to clear the intersection before the green signal ends.
Example — blocked intersection
You have a green light, but there is a traffic jam beyond the intersection and no room for your car.
You should not enter the intersection if this would mean remaining on it after the signal changes and blocking cross traffic.
Remember:
green light ≠ requirement to proceed immediately
First, you need to assess whether you can clear the intersection safely and in accordance with the rules.
S-1 does not guarantee conflict-free movement
An ordinary green S-1 signal does not mean that your manoeuvre will be conflict-free with other road users.
For example, when turning, the driver may still have to give way to:
- pedestrians,
- cyclists,
- other road users, where this follows from the rules governing the manoeuvre being performed.
This is one of the most important differences between S-1 and the S-3 directional traffic light.
2. Yellow signal
A yellow signal means:
- no entry beyond the traffic light,
- that a red signal is about to appear.
There is, however, an exception.
If, when the yellow signal appears, the vehicle is so close to the traffic light that it cannot be stopped before the traffic light without sudden braking, the driver may continue.
What does a yellow light not mean?
It does not mean:
"speed up so you can still make it through".
The exception exists to avoid dangerous sudden braking, not to allow deliberate acceleration before the red light appears.
3. Red signal
A red signal means no entry beyond the traffic light.
If the displayed signal requires the vehicle to stop, it must be stopped:
- before the line indicating the stopping position,
- if there is no such line — before the traffic light.
If the traffic light is located above the carriageway and there is no line indicating the stopping position, the vehicle must be stopped before the carriageway above which the traffic light is installed.
4. Red and yellow simultaneously
Red and yellow signals displayed simultaneously:
- still mean no entry beyond the traffic light,
- indicate that a green signal is about to appear.
You must not move off simply because the yellow light has appeared together with the red light.
You may move off only when a signal permitting entry appears.
5. S-1a — traffic lights for cyclists
The S-1a traffic light applies to cyclists:
- who are on a part of the road intended solely for cycle traffic, or
- who are entering such a part of the road.
The basic colours have meanings analogous to those of S-1.
For a car driver, the key point is to recognise that the S-1a signal is intended for cycle traffic and may control that traffic independently of signals for motor vehicles.
6. S-2 — conditional turn on red
The S-2 traffic light displays a red signal together with an additional signal in the form of a green arrow.
This signal permits a turn in the direction indicated by the arrow into the nearest carriageway at the intersection.
The conditional right-turn arrow is the most common.
The most important condition: stopping
Before turning, the driver must stop the vehicle before the traffic light.
Only after stopping may the driver continue if:
- this will not impede other road users,
- the manoeuvre can be performed safely.
Remember:
S-2 green arrow ≠ green light
S-2 gives conditional permission to turn.
Merely slowing down without coming to a complete stop does not satisfy the requirement.
Left S-2 arrow
If S-2 permits a left turn, it also permits a U-turn from the far left-hand lane, unless this is prohibited by the B-23 "no U-turn" sign.
7. S-3 — directional traffic light
The S-3 directional traffic light contains an arrow or arrows indicating the directions to which the signal applies.
S-3 signals apply only to drivers travelling in the directions shown by the arrow.
Green S-3 — conflict-free movement
A green S-3 signal means that, when travelling in the indicated direction, there is no conflict with other road users.
This fundamentally distinguishes S-3 from an ordinary S-1 signal.
Comparing S-1 and S-3
S-1 — green:
- permits entry,
- but other road users may still be present during the manoeuvre, and the appropriate rules must still be followed in relation to them.
S-3 — green directional arrow:
- applies only to the indicated direction,
- movement in that direction is organised as conflict-free.
Can you make a U-turn on S-3?
You must not automatically assume that an S-3 signal permitting a left turn also permits a U-turn.
This is an important difference compared with:
- the P-8b direction arrow,
- F-10/F-11,
- a left conditional S-2 arrow.
If traffic is controlled by an S-3 traffic light, the permitted movement follows from the direction indicated by the traffic light.
8. S-3a — directional traffic lights for cyclists
S-3a is the directional equivalent of traffic lights intended for cyclists.
It applies to cyclists:
- who are on a part of the road intended solely for cycle traffic, or
- who are entering that part of the road,
and who are travelling in the directions indicated by the arrows.
As with S-3, a green signal for the indicated direction means that movement is organised as conflict-free.
9. S-4 — traffic lights above a traffic lane
S-4 is used to open and close a specific traffic lane.
It is particularly important on reversible lanes, which may be marked by a P-5 line.
Green S-4
Permits entry into the traffic lane above which the traffic light is installed.
Red S-4
Prohibits entry into that lane.
Remember: S-4 traffic lights apply to a specific lane, not to the entire carriageway.
10. S-5 — signals for pedestrians
The S-5 traffic light displays signals for pedestrians.
Green
Permits entry onto the pedestrian crossing.
Flashing green
Means that:
- a red signal is about to appear,
- a pedestrian who is on the crossing should leave it as quickly as possible.
Red
Means that pedestrians must not enter the crossing.
For a car driver, observing pedestrian signals may help in assessing the situation, but it does not replace the signals intended directly for the driver or the driver's duties towards pedestrians.
11. S-6 — signals for cyclists at a cycle crossing
S-6 applies to a cycle crossing.
Green
Permits a cyclist to enter the cycle crossing.
Flashing green
Means that:
- a red signal is about to appear,
- a cyclist who is on the crossing should leave it as quickly as possible.
Red
Prohibits entry onto the cycle crossing.
12. S-7 — requirement to leave the traffic lane
An S-7 signal, whether steady or flashing, means:
- a requirement to leave the traffic lane above which it is displayed,
- a requirement to enter the part of the carriageway on the side indicated by the arrow.
S-7 may appear, for example, in connection with:
- road works,
- a lane closure,
- temporary traffic management.
It is not merely a warning. The signal requires the driver to leave the lane being used.
13. Flashing red signal
One flashing red signal or two alternately flashing red signals mean:
no entry beyond the traffic light or other device displaying these signals.
Such signals may appear, for example, at level crossings.
A flashing red light must not be treated as a warning signal that may be disregarded after exercising caution.
Flashing red = no entry beyond the signal.
14. Flashing or steady yellow warning signal
A flashing yellow signal displayed by a traffic light, or a yellow signal placed on an obstacle:
- warns of danger or an obstruction to traffic,
- requires particular caution.
It does not determine priority on its own.
If traffic lights at an intersection are operating only in flashing yellow mode, the driver must follow:
- signs regulating priority,
- other road markings and signs,
- the general rules.
15. Recommended speed displayed by light signals
A light signal in the form of white digits on a board or traffic light means entry onto a section of carriageway where driving at the displayed speed is recommended.
This is a recommended speed, not automatically a new speed limit.
It must not be confused with the B-33 sign.
16. Special signals for buses and trams
The road may also have white light signals intended for:
- buses and other regular public transport vehicles on dedicated lanes — SB traffic lights,
- trams — ST, STK and STT traffic lights.
For a car driver, the key point is to understand that these signals are not the basic traffic lights intended for them.
They may, however, help the driver assess what movement has been permitted for a bus or tram at the intersection.
Detailed rules on interactions with rail vehicles will be covered with priority and crossings over tram tracks.
How to analyse an intersection with traffic lights
Before entering, it is useful to follow a simple sequence:
- Which traffic light applies to my lane or direction?
- Is it S-1, S-2 or S-3?
- Which signal is currently being displayed?
- Can I clear the intersection without blocking it?
- Would my movement make it difficult for pedestrians or cyclists to leave the carriageway?
- Am I making a turn that requires me to take other road users into account?
- Do any additional prohibitory or mandatory signs restrict the direction in which I may travel?
- Is traffic being directed by an authorised person?
Only after considering all this information should you decide whether to enter.
Common pitfalls
1. A green S-1 signal does not give an unconditional right to enter. You must not enter if you would block the intersection or make it difficult for pedestrians or cyclists to leave the carriageway.
2. Yellow does not mean "I can make it if I speed up". As a rule, it prohibits entry; the exception protects against the need for sudden braking.
3. Red + yellow still means no entry beyond the traffic light.
4. S-2 requires a complete stop before the traffic light.
5. The S-2 green arrow and a green S-3 signal are two different things. S-2 is a conditional turn on red; S-3 is a directional traffic light.
6. S-1 and S-3 do not provide the same type of movement. S-3 indicates a direction of conflict-free movement.
7. Flashing red means no entry beyond the signal. Flashing yellow only warns of danger and requires particular caution.
8. Green does not override prohibitory and mandatory signs. Traffic light signals take precedence over signs regulating priority, not over all road signs and markings.
9. When stopping for a red signal, stop before the line indicating the stopping position, and only if there is no such line, before the traffic light.
Main traffic lights covered in this lesson
Show the list of signal devices and signalsHide the list of signal devices and signals
Sources
- Rozporządzenie Ministrów Infrastruktury oraz Spraw Wewnętrznych i Administracji z dnia 31 lipca 2002 r. w sprawie znaków i sygnałów drogowych — Chapter 5, in particular § 95–107.
- Consolidated text: Dz.U. 2019 poz. 2310, as subsequently amended.
- Annex No. 1 to the rozporządzenie w sprawie szkolenia osób ubiegających się o uprawnienia do kierowania pojazdami — part
officialTopic 1.5.
