Dipped-beam headlights, daytime running lights, main beam and position lights
Contents
Car lights perform two basic functions:
- they help the driver see the road,
- they make the car visible to others.
Choosing the correct lights depends on:
- the time of day,
- air transparency,
- road lighting,
- the presence of other road users,
- whether the vehicle is moving, stopped or parked.
The most important rule for a passenger car is:
when driving in conditions of normal air transparency, use dipped-beam headlights; from dawn to dusk, you may use daytime running lights instead.
1. Dipped-beam headlights — the basic lights for driving
Article 51(1) of Poland's Prawo o ruchu drogowym (the road traffic law) requires the use of:
dipped-beam headlights when driving in conditions of normal air transparency.
This means that dipped-beam headlights are the basic lawful option:
- during the day,
- at night,
- on a lit road,
- on an unlit road,
unless a particular situation requires or permits the use of other lights.
Important
There is no rule in Poland saying:
“you do not need any lights during the day”.
When driving a car, use:
- dipped-beam headlights, or
- daytime running lights when the conditions allow it.
2. Daytime running lights — only from dawn to dusk
Article 51(2) allows daytime running lights to be used instead of dipped-beam headlights, but only:
- from dawn to dusk,
- in conditions of normal air transparency.
Both conditions must be met at the same time.
You may drive with daytime running lights
Daytime, good visibility, no fog or heavy precipitation.
→ YES.
You may not treat daytime running lights as a substitute for dipped-beam headlights
- after dusk,
- before dawn,
- when air transparency is reduced.
→ in those conditions, daytime running lights are not sufficient as the basic lighting required by law.
DAWN → DUSK + normal air transparency
→ dipped-beam headlights OR daytime running lights
DUSK → DAWN
→ dipped-beam headlights / main beam where conditions allow
fog / heavy rain / snow reducing air transparency
→ Article 30 rules, not daytime running lights alone
3. “Dawn” and “dusk” are not fixed times
The rules do not specify one fixed time such as:
- 6:00 — dawn,
- 20:00 — dusk.
The time depends on:
- the date,
- the location,
- natural conditions.
So do not learn a rigid clock-based rule.
If it is getting dark:
→ the driver should use lights that ensure compliance with the rules and good visibility early enough.
4. Daytime running lights are not for illuminating the road at night
Daytime running lights are primarily intended to improve the visibility of the vehicle during the day.
They are not a substitute for dipped-beam headlights:
- at night,
- when driving in darkness,
- in poor visibility.
In some cars, the rear position lights may not be illuminated when daytime running lights are on.
Driving with daytime running lights alone in conditions for which they are not intended can therefore make the car very difficult to see from behind.
5. AUTO mode does not relieve the driver of responsibility
A modern car may automatically switch between:
- daytime running lights,
- dipped-beam headlights,
- and sometimes main beam as well.
The system is an aid.
The driver is responsible for using the correct lighting in the prevailing conditions.
The automatic system may respond incorrectly, for example during:
- fog in daylight,
- heavy rain,
- snowfall,
- driving in very bright surroundings with poor visibility.
A light sensor primarily measures light intensity and does not always assess actual air transparency.
Remember:
AUTO = assistance
AUTO ≠ transferring responsibility to the car
6. Main beam — when may it be used?
Main beam, colloquially called “full beam”, may be used:
- from dusk to dawn,
- on unlit roads,
- instead of dipped-beam headlights or together with them,
- provided it does not dazzle other drivers or pedestrians moving in a column.
This means that you cannot use it freely just because it is night.
Key condition
The road must be:
unlit.
On a properly lit section of road, main beam is not used as the ordinary way of driving.
7. When must you switch from main beam to dipped-beam headlights?
A driver using main beam must switch to dipped-beam headlights when approaching:
1. an oncoming vehicle
If one driver has switched from main beam to dipped-beam headlights:
→ the other driver must do the same.
2. a vehicle ahead
If the lights could dazzle its driver, for example through the mirrors.
3. a rail vehicle or water-transport vehicle
If it is close enough that its driver could be dazzled.
So this does not apply only to cars approaching from the opposite direction.
8. Do not wait until the last moment to switch off “full beam”
The rules require the lights to be switched when approaching a road user who could be dazzled.
Good practice is to react before the other driver is dazzled.
It should not work like this:
“I will switch off full beam only when the other car starts flashing its headlights at me”.
The driver should independently observe:
- the lights of an approaching vehicle,
- the lights of the vehicle ahead,
- the course of the road,
- reflections of light.
9. A vehicle beyond a crest or bend
On a winding or undulating road, another vehicle's lights may be visible before the vehicle itself.
If it can reasonably be anticipated that dazzling will occur shortly:
→ switch from main beam to dipped-beam headlights early enough.
Main beam is intended to improve safety, not to maximise viewing distance at the expense of others.
10. The car ahead of you can also be dazzled
A common mistake is to think:
“I switch off full beam only for oncoming cars”.
No.
If you are driving behind another vehicle, main beam can be reflected in:
- the interior mirror,
- the exterior mirrors.
If there is a possibility of dazzling the driver of the vehicle ahead:
→ switch to dipped-beam headlights.
11. Automatic main beam also requires supervision
An automatic “full beam” system may:
- detect a vehicle too late,
- assess the lights of a bicycle or motorcycle incorrectly,
- fail to recognise a vehicle positioned at an unusual angle,
- perform less effectively in precipitation or with a dirty windscreen.
The driver should be ready to switch the lights manually.
If the system dazzles others:
→ responsibility for correct use of the lights still rests with the driver.
12. Position lights do not replace dipped-beam headlights while driving
Position lights are primarily intended to indicate the presence and position of the vehicle, especially when stopping or parking in specified conditions.
They are not the basic lights for normal driving.
An incorrect approach is:
“it is a bit dark, so I will drive using only the position lights”.
When driving, Article 51 rules apply to:
- dipped-beam headlights,
- daytime running lights,
- main beam,
- and, in particular conditions, fog lights as well.
13. Parking lights and position lights
In some cars, parking lights can be switched on on only one side of the vehicle.
Their function is primarily to mark a parked or stopped car.
Do not confuse:
- parking lights,
- position lights,
- hazard warning lights.
Each has a different use.
14. Stopping in a traffic jam or at a red light
Article 51(7) provides that the rules governing lights while driving also apply, as appropriate, when stopping because of:
- traffic conditions,
- road traffic rules.
So, for example, when stopped:
- at a red light,
- in a traffic jam,
you generally continue to use the appropriate lighting.
Exception after more than 1 minute
If such a stop lasts more than 1 minute, the external lights may be switched off, but only if:
- on the same traffic lane,
- in front of your vehicle
- and behind it
other vehicles are stationary.
This is a specific exception, not a general permission to switch off the lights during every longer stop in a traffic jam.
15. Voluntary stopping or parking in conditions of insufficient visibility
Article 52 governs a different situation from a traffic jam.
If the driver of a motor vehicle:
- voluntarily stops the vehicle, or
- leaves it parked
in conditions of insufficient visibility:
→ they should use front and rear position lights or parking lights.
Example
Night, unlit street.
The car has been lawfully left beside the carriageway.
→ assess the requirement to use position lights/parking lights in accordance with Article 52.
16. When may the lights of a parked vehicle be switched off?
When stopping or parking, all lights may be switched off if the vehicle is:
- in a place lit sufficiently to ensure its visibility, or
- outside the carriageway and verge.
This means there is no rule saying:
“every car parked at night must have its lights on”.
What matters includes the vehicle's actual visibility and where it has been left.
17. Parking lights on the side facing the centre of the carriageway
For certain vehicles or combinations of vehicles of the relevant length, the rules allow parking lights to be used only:
on the side facing the centre of the carriageway.
The purpose is practical:
- to mark the side of the vehicle closer to moving traffic,
- to reduce energy consumption while parked.
For a Category B learner, understanding the distinction is more important than memorising design variants of lighting systems:
driving → lights required for driving
parking in insufficient visibility → position lights/parking lights
18. Fog, heavy rain and snow — daytime running lights alone are not enough
If air transparency is reduced by:
- fog,
- heavy precipitation,
- other causes,
Article 30 applies.
The driver of a motor vehicle must then switch on:
- dipped-beam headlights, or
- front fog lights,
- or both at the same time.
Therefore, during heavy rain in daylight, do not remain on daytime running lights alone.
Fog lights are discussed in detail in M4.2.
19. Tunnel — we do not teach an outdated rule
As discussed in M3.6, the rules currently in force do not establish a separate rule for a typical passenger car stating:
“the D-37 sign by itself always requires switching from daytime running lights to dipped-beam headlights”.
Article 51 permits daytime running lights to be used instead of dipped-beam headlights from dawn to dusk in normal air transparency.
At the same time, from a safety perspective, dipped-beam headlights are a better choice in a tunnel, because they improve the car's visibility, often including from behind.
So do not confuse:
- the legal minimum,
- a safe-driving recommendation.
20. Dirty or damaged lights
Choosing the correct type of light is not enough if the lamps:
- are dirty,
- are covered with snow,
- are damaged,
- do not work.
Before driving, it is worth at least visually checking the basic lighting.
A vehicle used in traffic must be maintained so that its use does not endanger safety.
Detailed technical requirements for vehicles return in Module 12.
21. Incorrectly aligned dipped-beam headlights can also dazzle
Main beam is not the only lighting that can disturb others.
Incorrectly aligned dipped-beam headlights may:
- dazzle oncoming drivers,
- reduce the actual distance over which the road is illuminated,
- make it harder to assess obstacles.
In a car with manual headlight levelling, a major change in vehicle load may require the setting to be adjusted in accordance with the vehicle instructions.
Do not adjust the headlights yourself to point “as high as possible”.
22. Number-plate lighting and other lights operate independently of the driver's choice
A car has more lights than those the driver selects manually in everyday use.
These include, among others:
- direction indicators,
- stop lamps,
- reversing lights,
- number-plate lighting.
Some of them operate automatically in connection with a particular action.
Their purpose and basic checks are discussed later in Module 4.
Step-by-step method for choosing the basic lights
Step 1 — what time of day is it?
From dawn to dusk
Proceed to assess air transparency.
From dusk to dawn
Use dipped-beam headlights, and on an unlit road you may use main beam where conditions allow.
Step 2 — what is the air transparency?
Normal
During the day:
- dipped-beam headlights or daytime running lights.
Reduced
Do not remain on daytime running lights alone.
Apply Article 30 rules:
- dipped-beam headlights,
- front fog lights,
- or both.
Step 3 — is the road unlit and is it night?
You may use main beam if you do not dazzle anyone.
Step 4 — are you approaching another road user whom you could dazzle?
Switch from main beam to dipped-beam headlights.
Step 5 — is the vehicle moving, stopped because of traffic, or parked?
This determines whether Article 51 or the parking rules in Article 52 apply.
Common pitfalls
1. Daytime running lights may be used instead of dipped-beam headlights only from dawn to dusk and in conditions of normal air transparency.
2. Fog or heavy rain may rule out driving with daytime running lights alone even during the day.
3. AUTO mode does not relieve the driver of responsibility for using the correct lights.
4. Main beam is used from dusk to dawn on unlit roads provided it does not dazzle others.
5. “Full beam” must also be switched off when it could dazzle the driver of a vehicle ahead through the mirrors.
6. Position lights are not an ordinary substitute for dipped-beam headlights while driving.
7. Stopping in a traffic jam and voluntary parking are two different situations, including for the rules on using lights.
8. When a stop caused by traffic lasts more than 1 minute, the lights may be switched off only if a specific condition is met — vehicles are stationary in front of us and behind us on the same traffic lane.
9. A car parked at night does not always have to have its lights on — Article 52 provides exceptions, including for a place that is sufficiently lit.
10. For a typical passenger car, the current rules do not create a separate requirement to use dipped-beam headlights solely because the car enters a tunnel; dipped-beam headlights nevertheless remain the safer choice.
Sources
- Ustawa z dnia 20 czerwca 1997 r. — Prawo o ruchu drogowym:
- Article 51(1)–(3) — dipped-beam headlights, daytime running lights and main beam,
- Article 51(5) — front fog lights on a marked winding road,
- Article 51(6)–(7) — special cases and stopping resulting from traffic,
- Article 52 — lights during voluntary stopping and parking,
- Article 30 — lights when air transparency is reduced,
- Article 66 — general requirement to maintain the vehicle in a condition that does not endanger safety.
- Rozporządzenie w sprawie warunków technicznych pojazdów oraz zakresu ich niezbędnego wyposażenia — technical requirements for vehicle lights.
- Annex No. 1 to the training programme —
officialTopic 1.14.
