Category BM1.4
Lesson 4 of 9

Mandatory signs

Contents

Mandatory signs tell a driver or another road user what they are required to do. Unlike prohibitory signs, they do not primarily say what is forbidden; instead, they specify the required direction of travel, how to pass a point or obstacle, or how to use the road.

Most signs in this group are round and blue with a white symbol.

When interpreting a mandatory sign, you need to establish:

  1. exactly what the requirement concerns,
  2. where the required behaviour must be carried out,
  3. how long the requirement applies,
  4. whether a supplementary plate below the sign changes its scope.

1. Required direction of travel — C-1 to C-8

Signs C-1–C-8 require the driver to travel in the direction shown by the arrows.

C-1 “turn right before the sign”

Requires you to turn right before the sign.

C-2 “turn right after the sign”

Requires you to turn right after the sign.

C-3 “turn left before the sign”

Requires you to turn left before the sign.

C-4 “turn left after the sign”

Requires you to turn left after the sign.

The key difference — “before” and “after”

With C-1–C-4, the direction of the arrow is not the only information. The position of your path relative to the sign itself is just as important.

C-5 “straight ahead only”

Requires you to continue straight ahead.

C-6 “straight ahead or right”

Allows two directions:

  • straight ahead,
  • right.

C-7 “straight ahead or left”

Allows:

  • going straight ahead,
  • turning left.

C-8 “left or right”

Requires you to choose one of two directions:

  • right,
  • left.

Going straight ahead is not permitted in this situation.

Where do C-1–C-8 apply?

Signs requiring a direction of travel apply at the next intersection or at the place where it is possible to change direction.

They may be placed:

  • beside the road,
  • on the extension of the centre line of the road or carriageway,
  • directly on the carriageway.

A supplementary plate reading “Does not apply to” with a symbol or description of a vehicle may be placed below signs C-1–C-10. It means that the vehicle shown is exempt from the requirement.


2. Which side to pass the sign or obstacle on — C-9, C-10 and C-11

C-9 “pass to the right of the sign”

Requires you to pass on the right-hand side of the sign.

C-10 “pass to the left of the sign”

Requires you to pass on the left-hand side of the sign.

C-11 “pass either side of the sign”

Allows you to pass the sign on either of the two sides shown.

These signs are often found at:

  • traffic islands,
  • obstacles,
  • traffic management features,
  • road works.

Remember: C-9 and C-10 do not mean “turn right” or “turn left at the intersection”. They indicate the side on which you must pass the sign or obstacle.


3. C-12 “roundabout”

Sign C-12 means that traffic at the intersection moves around the island or square in the direction shown on the sign.

On its own, C-12 mainly specifies how traffic moves.

C-12 together with A-7

If C-12 appears together with sign A-7 “Give way”, a driver already on the intersection has priority over a driver entering it.

This is one of the most important rules on how roundabout intersections are signed.

Remember:

  • C-12 → specifies movement around the island or square,
  • A-7 + C-12 → additionally gives vehicles already on the intersection priority over those entering it.

So do not learn the simplified rule that “at every roundabout, whoever is already on it has priority”. Always assess the complete set of signs.

We cover the priority rules and traffic arrangements at roundabout intersections in Module 2, and lane choice and the path to follow in Module 3.


4. C-13 “cycle path”

Sign C-13 marks a path intended for cyclists.

A cyclist must use a path marked in this way if it is provided for the direction in which they are travelling or intend to turn.

How long does C-13 apply?

The requirement expressed by sign C-13 applies until it is cancelled or until:

  • the place where sign B-1 is placed,
  • sign B-9,
  • sign C-16,
  • sign D-40 “residential zone”,
  • the next intersection.

C-13a “end of cycle path”

Marks the end of the path intended for cyclists.

Note: C-13 designates a path for cyclists. Do not confuse it with sign D-6a, which marks a cycle crossing over the carriageway.


5. C-14 “minimum speed”

Sign C-14 requires you to drive at a speed not lower than the value shown on the sign.

However, this requirement does not mean you must maintain that speed at all costs.

If:

  • traffic conditions,
  • the condition of the road,
  • visibility,
  • safety

require you to drive more slowly, the driver may — and should — reduce speed.

Example

C-14 shows 40 km/h.

In normal conditions, the driver should travel at no less than 40 km/h, while of course not exceeding the maximum permitted speed.

However, if a queue is forming ahead of the vehicle or the carriageway is icy, driving slower than 40 km/h is not a breach of the sign.

C-15 “end of minimum speed”

Marks the place where the requirement set by sign C-14 ceases to apply.

Do not confuse C-14 with B-33

  • B-33 sets the maximum speed,
  • C-14 sets the minimum speed.

6. C-16 “pedestrian path”

Sign C-16 marks a path, or part of a road, intended for pedestrians, who are required to use it.

The requirement applies until it is cancelled or until the place where one of the following is placed:

  • B-41 “no pedestrians”,
  • C-13 “cycle path”,
  • D-40 “residential zone”.

C-16a “end of pedestrian path”

Marks the end of the path intended for pedestrians.


7. Shared pedestrian and cycle path — C-13/C-16

The C-13 and C-16 symbols may appear on a single sign face.

The way they are separated is crucial.

Symbols separated by a horizontal line

If the cycle and pedestrian symbols are separated by a horizontal line, the path is a shared pedestrian and cycle path.

Pedestrians and cyclists use the whole width of a path marked in this way.

Symbols separated by a vertical line

If the symbols are separated by a vertical line, the cycle path and the pedestrian path run side by side (a segregated pedestrian and cycle path).

The side on which each symbol appears shows the part of the path intended for that group of road users.

C-13/C-16:

  • horizontal line → shared space,
  • vertical line → separate parts.

The combined C-13/C-16 sign may also be cancelled by sign C-13 or C-16.

This is a very important difference and a frequent topic in exam situations.

The detailed rules on interaction between cyclists and pedestrians are covered in M5.3–M5.5.


8. C-17 — required direction for vehicles carrying dangerous goods

C-17 “required direction for vehicles carrying dangerous goods” shows the direction that vehicles carrying specified dangerous goods must take at an intersection.

The sign uses the directions corresponding to signs:

  • C-2,
  • C-4,
  • C-5,
  • C-6,
  • C-7,
  • C-8.

A T-31 supplementary plate or appropriate wording may be placed below the sign.

T-31

It may limit the requirement expressed by sign C-17 to specified classes or groups of goods, or to a specified method of carriage.

At Category B level, the most important thing is to recognise what the sign does. Detailed ADR classifications are beyond the scope of this lesson.


9. C-18 “snow chains required”

Sign C-18 means that, on the road where it has been placed, the driver of a motor vehicle must use snow chains on at least two driven wheels.

A supplementary plate below the sign may indicate the type of vehicle to which the requirement applies.

C-19 “end of snow chains requirement”

Marks the place where the obligation arising from C-18 ceases to apply.

Remember: the regulations refer to at least two driven wheels, not simply to any two wheels of the vehicle.


When does a requirement end?

Not all mandatory signs work according to the same rule.

For example:

  • C-1–C-11 apply at the next intersection or the place where it is possible to change direction,
  • C-13 applies until it is cancelled or until specified places and signs,
  • C-14 lasts until C-15,
  • C-16 applies until it is cancelled or until specified signs,
  • C-13/C-16 may also be cancelled by C-13 or C-16,
  • C-18 lasts until C-19.

This is why you cannot apply a single simplification to mandatory signs, such as:

“every requirement ends at the intersection”.

You need to know how each specific sign works.


Common pitfalls

1. C-1 and C-2 do not mean the same thing. Both direct you to the right, but one requires you to turn before the sign and the other after it.

2. C-9 does not mean turning right at an intersection. It requires you to pass on the right-hand side of the sign or obstacle.

3. C-12 on its own does not automatically give priority to vehicles already on the roundabout. That meaning arises when C-12 is combined with A-7.

4. C-13 and D-6a have different functions. C-13 marks a cycle path; D-6a marks a cycle crossing.

5. C-14 does not require you to maintain the minimum speed when it is unsafe. Traffic conditions and safety may require you to drive more slowly.

6. With C-13/C-16, a horizontal line and a vertical line mean two different traffic arrangements.

7. C-18 requires snow chains on at least two driven wheels.


Full list of Group C signs covered in this lesson

Show the full list of signs
Sources
  • Rozporządzenie Ministrów Infrastruktury oraz Spraw Wewnętrznych i Administracji z dnia 31 lipca 2002 r. w sprawie znaków i sygnałów drogowych — in particular § 35–42.
  • Consolidated text: Dz.U. 2019 poz. 2310, as subsequently amended.
  • Annex No. 1 to the rozporządzenie w sprawie szkolenia osób ubiegających się o uprawnienia do kierowania pojazdami — part officialTopic 1.2.
↑